RV Products 8000 Series Instrucciones de operaciones descargar pdf (Pagina 4)

II.



Operation During Cooler Nights (Cooling



Do not expect the heating coil on your heater to glow.

Operation).



Because the fan draws in cold air and forces it over the coil,

the coil will not turn red. A hint of red may occur where the

It is important, when the outdoor temperature drops in the



moving air does not directly touch the coil.

evening or during the night to below 75°F, that the thermostat

(temperature control) be set at a midpoint between "Warmer"



Turn the selector switch to the "LOW HEAT"

and "Cooler". If the setting is at "Cooler", the cooler



position. At "LOW HEAT", the fan operates on

(evaporator) coil may become iced-up and stop cooling.



low speed with heat output at maximum.

During the day when the temperatures have risen above 75°F,

reset the thermostat switch to the desired setting.



Rotate the thermostat (temperature control) switch

to the position that is the most comfortable to you.

NOTE



The thermostat will turn the heater on when the

temperature of the air entering the air conditioning

Should icing-up occur, it is necessary to let the cooling



unit drops below this setting a few degrees and

(evaporator) coil defrost before normal cooling operation is



automatically turns off when the temperature of the

resumed. During this time, operate the unit in the "HIGH



air entering the air conditioner rises a few degrees

FAN" position with the system at maximum air flow. When



above this setting. The heater will continue to cycle

increased or full air flow is observed, the cooling coil should



on and off in this fashion until the selector switch

be clear of ice.



is turned to another mode of operation.

III.



Short Cycling

When an air conditioner is in operation, its compressor

circulates refrigerant under high pressure. Once off, it will

take two to three minutes for this high pressure to equalize.



Position the louvers to the desired direction the

discharge air is to flow.

Discharge air temperature can be controlled to some

extent by opening or closing the louvers.

The air conditioning compressor is unable to start against high



When the louvers are closed, the warmest localized

pressure. Therefore, once the air conditioner is turned off, it is



discharge air is achieved. Fully opened louvers

important to leave it off for two to three minutes before



will throw the warm discharge air to the back and

restarting.



front of the vehicle for more efficient circulation and

faster warm-up. Although the air temperature is

Short cycling the compressor (or starting it before pressures



lower with the louvers fully opened, the heating

have equalized), will in some instances, kick the circuit



capacity is still the same.

breaker or overload.

For Air Circulation Only (Refer To Figure 1 & 2, pg. 3).

IV.



For Heating ("Elect-A-Heat" Ceiling Assembly

Model Only) Refer To Figure 1 and 2, page 3).



Turn the selector switch for "LOW FAN" or for

maximum air flow, to "HIGH FAN".

The optional Elect-A-Heat heating assembly is intended to

take the chill out of the indoor air when the air is a few



Position the louvers to the desired direction the

degrees too cool for comfort. The heating assembly is an



discharge air is to flow.

effective "chill chaser". It is not a substitute for a furnace.

NOTE

When the selector switch is in the "LOW FAN" or "HIGH

FAN" position, the blower motor will operate continuously.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

RV Products 8000 Series Instrucciones de operaciones Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división RV Products 8000 Series