RV Products 6700 Series Instrucciones de operaciones descargar pdf (Pagina 9)

V. CEILING ASSEMBLY WIRING

(ALL MODELS)

1. Remove the inside ceiling assembly shroud or grille.

The ducted system grille is attached with four screws

(one near each corner). Free delivery system shrouds

are attached with two screws (one each end). Ducted

system grille is shown in Figure 5.

2. The short wire harness assembly found with this kit

must install onto the ceiling grille or shroud through

the return air section. Ducted system grilles are

totally in the return air stream. Choose any square

opening which will allow the wire assembly to be

untouched by sheet metal members when the grille is

reinstalled. The plastic plug will route through the

selected square opening. The remainder of the

assembly will be pulled through the opening until the

jack at the opposite end of the harness is through the

opening and prevented from further travel by the

stainless washer, which will not pass through the

grille. Carefully bend over the aluminum tabs on

either of the jack so as to capture the jack in the

ceiling assembly (See Figure 5). Make a small

opening in the filter material to allow passage of the

wiring before attaching the filter. Connect the plastic

plug to the mating receptacle on the end of the upper

unit solar wire harness. Reinstall the ceiling grille,

taking care that any excess harness wiring is

prevented from contacting sharp edges or being

pinched between two members. Use wire ties or

electrical tape if necessary to insure wire security.

Installation onto a free delivery system shroud is

similar to the method for grille attachment except

that the shroud return air louvers are longer and

somewhat narrower. The jack will fit snugly between

two louvers and slightly spread them apart. Orient

the aluminum tabs so as to capture the jack before

bending over the tabs. Again, insure that the jack or

wiring will not interfere with any structures upon

reassembly of the shroud.

FIGURE 5

-9-

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

RV Products 6700 Series Instrucciones de operaciones Pagina 9